Skip to main content

Menu

IoT 6 Channel Switch Module 5V Arduino Compatible

ARD2-2009
Photo of a 6 channel self-latching module 5VDC that is Arduino compatible.

$34.95

QTY Price
1 $34.95

Description

This is a 5V 6-Channel Switch Module capable of controlling various lighting, appliances, and other equipment with higher current. It can be controlled by a Arduino, Raspberry Pi or directly by a microcontroller (8051, AVR, PIC, DSP, ARM, MSP430, TTL logic).

Each channel has an LED indicating whether it is on or off. The board features three operation modes: self-locking, interlocking and trigger. [Jumper B]

Self-locking trigger once, the relay turns on, and then trigger again, the relay turns off. Each channel is independent and will not influence each other. Can be triggered by high level or low level [optional, Jumper C], and can simultaneously control 6 channels.

Trigger mode is trigger on: relay on; trigger off: relay off. Can be triggered by high level or low level [optional, Jumper C].

Interlocking is a typical application of a fan speed switch, when S1 or CH1 is triggered relay 1 latches on, then when S2 or CH2 is triggered relay 1 turns off and relay 2 latches on. Interlock Mode can only have one relay connected at a time. Can be triggered by high level or low level [optional, Jumper C].

Notes

  • Unit does not have safety approval in Australia for switching 230VAC mains
  • If using external trigger, you must unplug the jumpers [Jumper A]
  • If using 12V external trigger, you need a 5.1–6.8K resistor connected in series
  • If using a 24V voltage trigger, you need a 15–22K resistor

WARNING: Mishandling or incorrect or improper use of relays could result in serious
personal injury or DEATH, possible physical damage of the product, faulty operation or
create serious/dangerous hazards.

Please make sure that you read and understand how your relay/relay module board works, the voltage and current it is rated for, and the risks involved in your project BEFORE you even attempt to start putting it together. Seek professional and qualified assistance BEFORE you undertake ANY high power projects. Do your research and seek advice BEFORE undertaking a project using a relay. Please check your connections and test them BEFORE turning the power on.

Wiltronics accepts no responsibility for your project, or the risk/damage/fire/shock/injury/death/loss that it causes.

Please note: It is illegal in some countries to wire up a high power project without an electrician. Please check your country's rules/laws/regulations before you undertake your project. If you have any doubts - don't do it.

Test Code for Arduino

void setup(){
pinMode(7,OUTPUT);
}

void loop(){
digitalWrite(7,LOW);
delay(10000);
digitalWrite(7,HIGH);
delay(10000);
}

Specifications

Voltage

5V

Rated Load

DC: 28~30V/10A

Rated Continuous Current

5A

Max. Switch Voltage

30VDC

Board Colour

Red

Material

PCB

Signal Type

5V High or Low [Set by Jumper C]

Dimensions

Length (mm)

110

Width (mm)

57

Height (mm)

18

You Might Also Like

All prices are in Australian Dollars and include GST. GST will be removed from your order if you are ordering from outside Australia.
Products may differ from pictured.
All trademarks and trade names are the properties of their respective owners. Wiltronics disclaims any proprietary interest in trademarks and trade names other than its own.

We use cookies to ensure you have the best experience on our site. If you continue to use this site you consent to the use of these cookies. OK

Find out more in our Privacy Policy